EDGEFRAME
Symetrix Edge Digital Network Controller
Share:
Symetrix Edge DSPs are equipped with 128 64×64 redundant Dante channels. The Dante protocol enables ultra-reliable multi-channel audio networking over IP. Together, Symetrix and Dante provide the fastest possible way to implement, control, and maintain a system of networked DSPs and accessories – including third party Dante-enabled microphones, loudspeakers, power amps, and mixing consoles. Total Input/Output Flexibility. Multiple control options include low-cost Symetrix ARC wall panels and an easy to generate SymVue Windows virtual GUI. The human readable Composer Control Protocol supports programming of third-party touch screens and control devices. An Embedded Web Server for Status and Even More Control. Edge’s embedded web server displays I/O levels, diagnostics data, and hosts ARC-WEB – a browser-based interface for smart phones, tablets, and computers.
General
– Processors: 1 x Analog Devices SHARC 21489 @ 400 MHz SIMD
– Raw processing capacity: 400 MIPS, 1.6 GFLOPS
– Sampling Rate: 48 kHz, ± 100 ppm
– Frequency Response A/D/A: 20 Hz – 20 kHz, ± 0.5 dB
– Dynamic Range A/D/A: 114 dB, A-weighted
– Channel Separation A/D/A: 108 dB @ 1 kHz, +24 dBu
– Latency A/D/A: 0.88 mS, inputs routed to outputs
– Delay memory: 174 mono seconds per Edge frame
– Analog control inputs: 0-3.3 VDC
– Recommended external control potentiometer: 10k Ohm, linear
– Logic outputs: Low 0V when active, pulled high 5V when inactive
– Logic output maximum external power supply voltage: 24 VDC
– Logic output maximum external power supply current sinking: 50 mA
– Logic output maximum output current: 10 mA
– RS-232 accessory serial I/O: 38.4 kbaud default, 8 data bits, 1 stop bit, no parity, no flow control wired straight-through, only pins 2, 3, and 5 required
– RS-485 serial I/O: 38.4 kbaud default 8 data bits, 1 stop bit, no parity, no flow control. May be broken out of ARC port
– Ethernet Cable: Standard CAT5, maximum device to device length = 100 meters
– Dante Cable: Standard CAT6, maximum device to device length = 100 meters
– ARC Cable: Standard CAT5, distance dependent upon load and number of devices
– Maximum devices per system: 32 units per Site File
– Maximum stored presets: 1000
Mechanical Data
– Space Required: 1U WDH: 18.91 in x 9.5 in x 1.72 in / 48.02 cm x 24.13 cm x 4.37 cm. Depth does not include connector allowance. Allow at least 3 inch additional clearance for rear panel connections. Additional depth may be required depending upon your specific wiring and connections
– Electrical: 100-240 VAC, 50/60 Hz, 45 Watts maximum universal input and/or suitable 24 VDC / 2.0 Amp auxillary power source. No line voltage switching required
– Ventilation: Maximum recommended ambient operating temperature is 30 C / 86 F. Ensure that the left and right equipment sides are unobstructed 5.08 cm, 2 in. minimum clearance. The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc
– Certifications or Compliance: UL 60065, cUL 60065, IEC 60065, EN 55103-1, EN 55103-2, FCC Part 15, RoHS
